Keysolved

What is an immobiliser?

An immobiliser stops the engine running unless it recognises the key's transponder. How it works, and where Keysolved shows the system for a car.

Updated

An immobiliser is the security system that stops the engine running unless it recognises the key. When you switch on, the car reads the transponder chip in the key, checks it against the keys it has stored, and only then lets the engine start. Programming a key means getting the immobiliser to accept a new one.

How it works

  • The key carries a transponder chip. It needs no battery for this, which is why a flat fob usually still starts a car with a blade.
  • An aerial round the ignition barrel or near the start button reads the chip.
  • A control unit decides whether the key is one of the car's own. Depending on the car this is a module of its own or part of another one, such as the engine ECU, the body control module or the instrument cluster. See ECU and BCM.
  • The engine management only runs once the immobiliser has said yes.

Because the stored keys live in the car, adding a key usually needs the car's security code, a working key, or both. See PIN codes.

How Keysolved shows it

On a vehicle page, for subscribers:

  • Immobiliser & system gives the Immobiliser architecture and Security model for that car, where we have them on record.
  • How to program it gives the steps, with Security Code Required when the job needs a code.
  • Transponder chip and Chip family in At a glance tell you what the immobiliser expects to read.

For a car showing an immobiliser warning, read immobiliser fault diagnosis. If the car has an extra security device fitted after it left the factory, see ghost immobilisers.

FAQ

Common questions

No. The immobiliser stops the engine running. Locking and unlocking is the remote side of the key, which is a separate system with its own programming.

Still stuck?

Tell us what you were trying to do and what happened. Include the vehicle or the page if it's about one. We read every message.