Keysolved

Toyota Venza key battery

1st gen (AV10)

2009–2015
  • Smart keyCR1632
  • Remote head keyNot confirmed

    We haven't confirmed this one. Open the key and read the code on the old cell, then buy the same.

How to change a smart key battery
  1. Slide the release catch and pull out the emergency key blade.
  2. Wrap the tip of a small flat screwdriver in tape or a cloth, put it in the slot the blade leaves and twist gently to part the case. Keep it off the circuit board and contacts.
  3. Note which way up the old cell sits before you lift it out. It varies by key, so don't assume + is up.
  4. Fit a new CR1632 the same way up, holding it by the edges. Leave any grease on the contacts.
  5. Clip the case back together and test the buttons at the car. Most keys work straight away with no reprogramming.
  6. Keep new and old cells away from children. A swallowed button battery can cause serious injury within two hours.
Full Venza 1st gen key record

For locksmiths · 1st gen

  • KeysSmart key · Remote head key
  • Tools confirmed10
  • Transponder chipSubscribers
  • Programming procedureSubscribers
Subscribe for the full recordFull Venza 1st gen key record

Questions

Toyota Venza key battery questions

1st gen (2009–2015): CR1632 in the smart key.

Also on Keysolved